Publicidad
Idiomas disponibles
Idiomas disponibles
Reverse
the strike
1.
Use a small flat-blade
screwdriver
to remove
plug strip from the dryer door opening.
Slide
the head of the screwdriver
under the plugs, being certain
not to scratch
the dryer surface.
I.ifl up.
2.
Remove the strike
3.
Insert strike on the opposite
side.
(
A
A. Plug strip (cannot be seen from thi_ angle)
B. Door strike
Reinstall the door
1.
Reattach door to dryer front panel with
the 4 screws.
1.
Check that all parts are now installed.
If there is an extra part, go back through
the steps to
see which
step was skipped.
2.
Check that you have all of your tools.
3.
Check the dryer's final location.
Be sure the vent is not crushed
or kinked.
4.
Check that the dryer is level. See "level
Dryer."
Electrical
Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow
these instructions can result indeath,
fire, or electrical
shock.
®
\
\\\\\
5_
6.
7.
8.
9.
10.
A. Dryer front panel
B. Door assembly
11.
2.
Check for fingerprints
on the glass. Clean
glass if necessary.
3.
Close door and check that it latches securely.
Plug into a grounded
3 prong outlet.
Turn on power.
Remove
any protective
film or tape remaining
on the dryer.
Dispose
of/recycle
all packaging
materials.
Read "Dryer
Use."
Wipe
the dryer drum interior
thoroughly
with
a damp cloth to remove
any dust.
Select a Timed
Dry heated cycle, and start the dryer. Do not select the Air Only
[emperature
setting.
If the dryer will not start,
check the following:
•
Controls
are set in a running
or "On"
position.
•
Start button
has been pushed firmly.
•
Dryer is plugged
into a grounded
3 prong outlet.
•
Electrical
supply
is connected.
•
Household
fuse is intact and tight, or circuit
breaker has not tripped.
•
Dryer door is closed.
When
the dryer has been running
for 5 minutes,
open
the dryer door and feel for heat. [f
you feel heat, cancel
cycle and close door. If you do not feel heat, turn off the dryer and
check that the gas supply
line shutoff
valve is open.
•
[f the gas supply
line shutoff
valve is closed,
open
it, then repeat the 5-minute
test as
outlined
above.
•
If the gas supply
line shutoff valve is open,
contact
a qualified
technician.
17
Publicidad
