Operation; Starting And Stopping; Locking The Machine; Using The Variable Speed Control - Delta 23-198 Manual De Instrucciones

STARTINg ANd STOPPINg

Make sure that the switch is in the
"OFF" position before plugging cord
into outlet. Do not touch the plug's metal prongs when
unplugging or plugging in the cord.
The on/off switch (A) is located on the front of the
grinder. See Figure 6. To turn the machine "ON", move
the switch up to the "ON" position. To turn the machine
"OFF", move the switch down to the "OFF" position.

LOCKINg ThE MAChINE

IMPORTANT: When the machine is not in use, the
switch should be locked in the "OFF" position to
prevent unauthorized use.
To lock the machine, remove the switch key (B) by
pulling it straight out. See Figure 7. With the switch key
removed, the switch will not operate.
Should the switch toggle be removed while the
grinder is running, the machine can be turned "OFF,"
but cannot be restarted unless the switch toggle is
re-inserted.
In the event of a power outage (such
as a breaker or fuse trip), always move
the switch to the "OFF" position until the main power is
restored.
USINg ThE vARIABLE SPEEd
CONTROL
The grinder is equipped with a variable speed control,
located beside the power switch. When the variable
speed control knob is positioned at the far left position
(counter clockwise), the RPM is 2000. The rotation
increases when the variable speed control knob is
turned clockwise. Positioned far right, the RPM is 3400.

USINg ThE FLExIBLE LAMP

The flexible lamp operates independently of the grinder.
To turn the lamp on and off, rotate the switch located at
the top of the lamp.
To reduce the risk of fire, use a 40-watt
or smaller, 120 volt, reflector track type
light bulb (not supplied). A standard household light
bulb should not be used. The reflector track type light
bulb should not extend below the lampshade.

OPERATION

11
FIgURE 6
FIgURE 7