Toyota Sistema manos libres Bluetooth Manual Del Propietário página 18

Placing a call
You can place a hands-free call using the hands-free system's phone menu in the following ways:
• using the system's contact list
• digit dial using voice recognition
• using the handset device's voice commands
• using redial
• using the handset device's memory dial
• dial a number from the handset device.
A handset device must be connected to hands-free system to use these features. At anytime, a
press and release of the END button will terminate the dialling operation.
Placing a call using the contact list
A valid contact must be stored in the hands-free system's Contact List to use this feature.
1 Press and release the MULTI-FUNCTION button.
The hands-free system responds: Phone menu. {Say a command}.
2 When prompted, say "CALL <NAME>".
The hands-free system responds: {Call <name> yes or no?}
 If the contact recited by the hands-free system is correct, say "YES".
The hands-free system responds: Calling <name>.
Note: When in Expert Mode, the call <name> yes or no? is bypassed.
Placing a call with voice recognition
You can enter a phone number as 1 or more segments of digits. A segment can include up
to 15 digits. An entire number can include no more than 2 digits. You can also use +, *, or #
characters when dialling a number. "WAIT" and "PAUSE" commands are also accepted.
Calling with a whole number
1 Press and release the MULTI-FUNCTION button.
The hands-free system responds: Phone menu. {Say a command}.
2 When prompted, say "DIAL NUMBER".
The hands-free system responds: Number please?
 Dictate the number as a single set of digits (without pauses between digits).
The hands-free system recites the digits heard.
4 If the number recited by the hands-free system is correct, say "DIAL" " (or "YES") to dial the
number.
The hands-free system responds: Dialling.
Bluetooth 17
®