Assembly And Adjustments - Berner 061355 Instrucciones De Manejo

E N G L I S H
use under humid conditions or in presence of fl ammable
liquids or gases.
DO NOT use grinding wheels other than center
depressed wheels and fl ap-disc.
This heavy-duty angle grinder is a professional power
tool. DO NOT let children come into contact with the
tool. Supervision is required when inexperienced
operators use this tool.
a. trigger switch
b. lock-off button
c. spindle lock button
d. spindle (fi g. 8)
e. side handle
f. abrasive wheel
g. anti-lock up backing fl ange
h. threaded clamp nut
i. guard (type 27)
j. battery pack
k. battery release buttons
Electrical safety
The electric motor has been designed for one voltage
only. Always check that the battery pack voltage
corresponds to the voltage on the rating plate. Also
make sure that the voltage of your charger corresponds
to that of your mains.
Your Berner charger is double insulated in
accordance with EN 60335; therefore no earth
wire is required.
If the supply cord is damaged, it must be replaced by
a specially prepared cord available through the Berner
service organization.
Mains plug replacement
(U.K. & Ireland only)
DANGER:
• Should your mains plug need replacing
and you are competent to do this,
proceed as instructed below. If you are
in doubt, contact an authorized Berner
repair agent or a qualifi ed electrician.
• Disconnect the plug from the supply.
• Cut off the plug and dispose of it safely;
a plug with bared copper conductors is
dangerous if engaged in a live socket
outlet.
• Only fi t 13 Amperes BS1363A approved
plugs fi tted with the correctly rated fuse
(1).
• The cable wire colours, or a letter, will be
marked at the connection points of most
good quality plugs. Attach the wires to
their respective points in the plug (see
below). Brown is for Live (L) (2) and Blue
is for Neutral (N) (4).
• Before replacing the top cover of the
mains plug ensure that the cable restraint
(3) is holding the outer sheath of the
cable fi rmly and that the two leads are
correctly fi xed at the terminals crews.
WARNING: NEVER use a light socket.
NEVER connect the live (L) or neutral (N)
wires to the earth pin marked E or
Using an extension cable
An extension cord should not be used unless absolutely
necessary. Use an approved extension cable suitable
for the power input of your charger (see technical data).
The minimum conductor size is 1 mm
length is 30 m.
When using a cable reel, always unwind the cable
completely.

ASSEMBLY AND ADJUSTMENTS

WARNING: Prior to assembly and
adjustment, always remove the battery pack.
Always switch off the tool before inserting or
removing the battery pack.
WARNING: Use only Berner battery packs
and chargers.
Inserting and removing the battery pack
into the tool (fi g. 2)
WARNING: To reduce the risk of serious
personal injury, turn tool off and
disconnect battery pack before making
any adjustments or removing/ installing
attachments or accessories. An accidental
start-up can cause injury.
30
.
2
; the maximum