Grass Catcher - Sears Craftsman EZ3 917.387160 Manual Del Propietário Y Guía

NOTE: We do not recommend shaq3ening
blade - but if you do, be sure the blade is
balanced.
TO SHARPEN BLADE
Care should be laken to keep the blade
balanced, An unbalanced blade will cause
eventuaJ damage to lawn mower or engine,
o The blade can be sharpened with a file or
on a grinding wheel. Do not attempt to
sharpen while on the mower.
,, To check blade balance, drive a nail into a
beam or wall. Leave about one inch of the
straight nail exposed. Place center hole of
blade over the head of the nail. tf blade is
balanced, it should rem_n in a horizontal
position_ If either end of the blade moves
downward, sharpen the heavy end until the
blade is balaneedl
GRASS CATCHER
, The grass catcher may be hosed with
water, but must be dry when used,
, Check your grass catcher often for damage
or deterioration. Through normal use it will
wear. If catcher needs replacing, replace
only with a manufacturer approved
replacement catcher. Give the lawn mower
model number when ordering.
Blade Crank shaft
adaptor ..__ keyway
Biade. Key__./t'_, _,-"'_
washer Trailing- adaptor
edge
ENGINE
.UBRICATION
1so only high quality detergent oil rated
_lth API service classifiOation SF, SH or
iG. Select the oil's SAE viscosity grade
_ccording to your expected operating
_mperature. . ,.
SAE VISCOSITY GR&DES
NOTE: Although multi_viscosity oils
(5W30, 10W30 etc.) improve starting in
cold weather, these multi--.viscosity oils
will result in increased oil consumption
when used above 32°F. Check your.
engine oil level more frequently to avoid
possible engine damage from running low
on oil.
Change the oil after every 25 hours of opera-
tion or at least once a year if the lawn mower
is not used for 25 hours in one year.
Check the crankcase oil level before
starting the engine and after each five (5)
hours of continuous use. Tighlen oil plug
securely each time you check the oil level.
TO CHANGE ENGINE OIL
NOTE: Befol_e tipping lawn mower to drain
oil, drainfuet tank by running engine until
fuel tank is empty.
• Disconnect spark plug wire from spark
plug and place wire where it cannot
come in contact with spark plug.
• Remove engine oil cap; lay aside on a
clean surface.
° Tip lawn mower on its side anddrain ofl
into a suitable container. Rock lawn
mower back and forth to remo,)e any oil
trapped inside of engine.
, Wipe off any spilled oil on lawn mower
and on side of engine.
• Fil! engine with oil. Fill only to the "FULL."
line on the dipstick_ DO NOT OVER
FILL
• Replace engine o11cap.
° Reconnect spark plug wire to sparl{
plug.
Container
AIR FILTER
Your engine will not run properly and may
be damaged by using a dirty air filter.
Replace the air filter every year, more
olten if you mow in very dusty, dirty
conditions° Do not wash air filter.
.Rernove the air filter cover by turning
counterclockwise to the stop and pull
away from collar,
• Remove filter from inside of cover.
• Clean the inside of the cover and the
12