Inserting The Batteries; Handling Batteries; Setting The Clock; Radio Reception - Silvercrest KH 2187 Instrucciones De Uso

Attention!
Do not permit small children to play with the
plastic packaging. There is a risk of suffocation!
• Position the radio alarm on a level and horizontal
surface.

Inserting the batteries

Power-cut protection
Through the insertion of a 9 V block battery (Type
6LR61) you will avoid that, in the event of a power
failure, the functioning of the device is interrupted
and, as a result, saved settings, such as time and alarm
time, are lost. The battery ensures that the radio
alarm continues to function with an emergency
operation, also during a power failure. On restoration
of the power supply, the correct time will appear
automatically on the display
Note:
The alarm, radio and display do not function
with battery-power.
• Open the battery compartment
a 9 V block battery (Type 6LR61).

Handling batteries

Leaking batteries can cause damage to the
radio alarm.
• If you do not intend to use the device for an
extended period, remove the battery.
• Should the batteries leak, clean the battery
compartment with a dry cloth whilst wearing
protective gloves.
Note:
Rechargable batteries cannot be charged via
the battery connection. In the event of an extended
power cut (several hours), the clock and alarm
times must be checked and possibly re-adjusted.
f
.
w and insert
Assembly
Before operating the device, make sure that it is in
a faultless condition. If it is not, it may not be used.
• Insert the plug into a power socket. Select a power
socket that is at all times easily accessible, so that
the plug can be quickly withdrawn in the event of
a malfunction.

Setting the clock

When you take the device into use for the first
time after inserting a new battery:
Whilst pressing and holding the button
• Repeatedly press, or press and hold, the button
HOUR
y
to set the hours.
HOUR
• Release the
hour indicator is shown in the display
• Repeatedly press, or press and hold, the button
MIN MINUTE
resp.
MIN
• Release the
as the required minute indicator is shown in the
f
display .
The programmed time setting is automatically accepted
as soon as the button

Radio Reception

• Place the slider switch
• Ensure that the switch
RADIO
position .
• Turn the volume regulator
• Select the radio frequency range by using the
waveband selector
• Now select the desired radio station by turning
TUNING
the regulator
- 29 -
TIME
y
button as soon as the required
f
u
to set the minutes.
MINUTE
u
resp. button as soon
TIME
s
is released.
h at the position
j
RADIO/ALARM
is at the
g
to a midway position.
BAND
k .
l
.
s :
.
ON
.