General Instructions; Cleaning Instructions - CASUALPLAY Ryder Instrucciones De Uso

READ THESE INSTRUCTIONS CAREFULLY BEFORE USE AND
KEEP THEM FOR FUTURE REFERENCE.
YOUR CHILD'S SAFETY MAY BE AFFECTED IF YOU DO NOT
FOLLOW THESE INSTRUCTIONS.
WARNING: IT MAY BE DANGEROUS TO LEAVE OUR CHILD UNATTENDED.
WARNING: ENSURE THAT ALL THE LOCKING DEVICES ARE ENGAGED BEFORE
USE.
WARNING: THIS PRODUCT IS NOT SUITABLE FOR RUNNING OR SKATING.
• The original equipment must not be modified.
• After it has been installed for a while, tighten up the fastening screws and check the
other components of the product.
• Always use the disabled access ramps, avoid going down kerbs and uneven ground.
• We recommend a maximum weight of 20 kg.
• Do not use accessories non approved by the manufacturer.
• This platform has been designed to carry only one child.
ASSEMBLING THE RYDER (see illustration 1)
• Screw the wheel bearing support onto each edge of the lower part of the platform.
• Place the non-slip pads on both sides of it, inserting and pressing the pivots into the
slots.
FITTING THE RYDER ON VINTAGE, VINTAGE 2 AND JAZZ (see illustrations 2-10)
• Pull the outer part of each connector to open the fastening hook (fig.2).
• Position the connectors in the rear tube of the pushchair (fig.3) and press the hooking
part until it clicks indicating it is correctly fastened (fig.4).
• Follow the instructions in reverse order to remove the Ryder (fig.5).
• Adjust the platform height to the high or low position by pulling the adjustment part
outwards (fig.6), lowering or raising the wheels and release it when they are at the
correct height (fig.7). Use the low position for pushchairs VINTAGE, VINTAGE 2 and
JAZZ.
• When the Ryder is not going to be used, it can be folded up and secured with the
fastening strap (fig.8).
• To install it, unfasten the rear central part of the basket then pass the upper part of the
strap through its support tube (fig.9-10). Next, fasten the basket again.

CLEANING INSTRUCTIONS

• Clean the platform with a damp cloth (never use abrasive products or solvents).
• For the plastic parts and wheels, use water and a mild detergent.

GENERAL INSTRUCTIONS

7