Dometic SP950C Instrucciones De Montaje página 8

Guarantee
Fit the fastening frame and the condenser at the Volvo FH as follows:
I
NOTE
Only install the condenser unit after you have attached the mounting
frame on the rear wall of the truck.
➤ Insert and tighten the four M8 x 35 bolts, eight U washers M8 8.4 x 16 mm and
four M8 retaining nuts (fig. 1, page 3) in the mounting frame for the condenser
unit.
➤ Remove all four M8 nuts and M8 8.4 x 16 mm U washers from the side spoiler
fastening (fig. 2 1, page 4).
A
NOTICE!
Secure side spoiler from falling.
➤ Place the fastening frame onto the M8 bolts and attach using the M8 nuts and
M8 8.4 x 16 mm U washers provided (fig. 2 1, page 4).
➤ Put the the four large M8 8.4 x 24 mm U washers as spacer discs onto the
protruding screws on the fastening frame (fig. 2 2, page 4).
➤ Place the condenser unit on the projecting bolts of the mounting frame and bolt
to the four U washers M8 8.4 x 16 mm and four M8 retaining nuts (fig. 3,
page 5).
➤ Check that all bolts are still tight after travelling approximately 200 km.
6 Guarantee
The statutory warranty period applies. If the product is defective, please contact the
service partner in your country (see dometic.com/dealer).
Our experts will be happy to help you and will discuss the warranty process with you
in more detail.
8
CoolAir SP950C, SPX1200C
EN