Cassette Tape - Panasonic SC-PM45 Instrucciones De Funcionamiento

Cassette tape

Basic play Basic play
1 Press [0] on top of the unit.
Insert the cassette.
2
Forward side
3 Close the lid by hand.
Press [TAPE 3] to start play.
4
To play the other side of the cassette, turn the cassette
over.
To Action
Press [CLEAR 7].
stop tape playback
Press [TAPE 3] when the unit is OFF with
start one-touch play
the cassette loaded.
fast-forward and Press [ /REW/4] or [ /FF/¢] in the
rewind stop mode.
Note
• Tapes exceeding 100 minutes are thin and can break or get caught
in the mechanism.
• Endless tapes can get caught up in the deck's moving parts if used
incorrectly.
TPS (Tape Program Sensor) TPS (Tape Program Sensor)
This function enables you to search the beginning of a track,
up to a maximum of 9.
Press [ /REW/4] or [ /FF/¢] during play.
Play resumes from the track found.
Note
TPS may not function properly:
• with short silent parts
• when noise occurs between tunes
• if silent parts are found within tunes
Use normal position tapes.
High position and metal position tapes can be used, but this
unit will not be able to record or erase them correctly.
Preparation
Wind the leader tape so that recording can begin
immediately.
1
0
2
Insert inside the
guides
3
Erasure prevention Erasure prevention
The illustration shows how to remove the tabs to prevent
recording. To record on the tape again, cover as shown.
Recording Recording
Insert the cassette to be recorded.
Select the source to be recorded.
7
Radio recording:
Tune in the station. ( ➡ page 10)
7
Disc or USB recording:
1 Disc
Insert the disc you want to record.
Press [CD 6] and then [
USB
Connect the USB mass storage device. ( ➡ page 13)
Press [USB 6] and then press [CLEAR
2 Prepare the desired recording mode.
To Action
record
Program the tracks you want. (
programmed
tracks
record Press [PLAY MODE] to select your desired
➡
specifi c tracks
mode. (
7
Music port recording:
Connect the portable audio equipment. ( ➡ page 13)
Press [MUSIC PORT].
Play the portable audio equipment.
8
Press [¶ REC/ ] to start recording.
To Action
Press [CLEAR 7].
stop recording
stop recording
1) Press [¶ REC
temporarily
2) Press again to resume recording.
record on the other Turn the cassette over and press
side of the tape
[¶ REC
erase a recorded 1) Insert the recorded cassette.
2) Press [TAPE 3] and then [CLEAR 7].
sound
3) Press [¶ REC/
Side A
Tab for side B Tab for side A
To re-record
Normal tape
CLEAR 7
].
7
] twice.
➡
page 8)
page 7)
8
/
].
8
/
].
8
].
Adhesive tape
9
9