AEG X91484MI1 Manual De Uso página 4

4 www.aeg.com
The minimum distance between the
supporting surface for the cooking
equipment on the hob and the lowest part
of the range hood must be not less than
50cm from electric cookers and 65cm from
gas or mixed cookers. If the instructions for
installation for the gas hob specify a greater
distance, this must be adhered to.
Warning! Installation and electrical
connection, may only be carried out by
authorised technicians.
4. MAINTENANCE
ATTENTION! Before performing any
maintenance operation, isolate the
hood from the electrical supply by
switching off at the connector and
removing the connector fuse.
Or if the appliance has been connected
through a plug and socket, then the plug
must be removed from the socket.
The cooker hood should be cleaned
regularly (at least with the same frequency
with which you carry out maintenance of the
fat filters) internally and externally. Clean
using the cloth dampened with neutral liquid
detergent. Do not use abrasive products.
DO NOT USE ALCOHOL!
Warning! Failure to carry out the basic
cleaning recommendations of the
cooker hood and replacement of the
filters may cause fire risks. Therefore,
we recommend observing these
instructions.
The manufacturer declines all responsibility
for any damage to the motor or any
fire damage linked to inappropriate
maintenance or failure to observe the above
safety recommendations.
4.1 Grease filter - This must be cleaned
once a month (or when the filter saturation
indication system – if envisaged on
the model in possession – indicates
this necessity) using non aggressive
detergents, either by hand or in the
dishwasher, which must be set to a low
temperature and a short cycle.
When washed in a dishwasher, the grease
filter may discolour slightly, but this does
not affect its filtering capacity.
X91484MI1 - X99484MD1
X91484MI2 - X99484MD2
X91484MI3 - X99484MK1
X91484MI4 - X99484MK2