Delta JT360 Manual De Instrucciones página 19

ADJUSTING FENCE POSITIVE STOPS
The fence on this jointer is equipped with positive stops
that allow you to rapidly tilt the fence to the 90 and
45 degree angle to the table in the inward or outward
position. To check and adjust the positive stops, proceed
as follows:
1. Position the fence at 90 degrees to the table. Make
certain the end of plunger (A) Fig. 50, is engaged
in notch (B) in index collar as shown, and tighten
lockhandle (C).
2. Place a square (D) Fig. 51, on the table and against
the fence and check if fence is 90 degrees to table.
3. If an adjustment is necessary, loosen set screw (E)
Fig. 50, in the index collar and loosen fence locking
handle (C).
4. Using the 90 degree edge of the square, tilt the fence
until you are certain the fence is 90 degrees to the
table and tighten lockhandle (C) Fig. 50, and set
screw (E).
5. Loosen lockhandle (C) Fig. 52, pull out and turn
plunger (A) and tilt fence out as far as it will go. Then
tighten lock handle (C).
6. Using square (D) Fig. 52, check to see if the fence
is at a 45 degree outward angle from the table, as
shown.
7. If an adjustment is necessary, loosen lockhandle (C)
Fig. 52. Loosen locknut (F) and turn adjusting screw
(G) until fence is tilted 45 degrees outward. Then
tighten locknut (F).
8. Loosen lockhandle (C) Fig. 53, and tilt fence inward
as far as possible, as shown, and tighten lockhandle
(C).
9. Using a square (D) Fig. 53, check to see if the fence
is at a 45 degree inward angle to the table, as shown.
10. If an adjustment is necessary loosen locknut (J)
Fig. 54, and turn adjusting screw (H) until fence is
tilted 45 degrees in. Then tighten lock nut (J).
Fig. 50
E
B
Fig. 51
Fig. 52
G
F
Fig. 53
Fig. 54
19 - English
A
D
C A
D
C
D
H
J
C