Ibiza sound MX802 Manual De Instrucciones página 3

CHANNEL CONTROL SECTION:
⑧ MUTE Switch
When depressed, this switch mutes the signal of the channel to all outputs.
⑨ MUTE Indicator
Press MUTE switch and the indicator lights up in red.
⑩ PEAK indicator
The peak level of the post –EQ signal is detected and the PEAK indicator light yellow when the level
reaches 3dB below clipping.
⑪ PFL switch
Depress this switch to feed to the channels pre-channel fader signal into the PFL bus, so that you can
monitor the signal from the PHONES jack. To turn PFL feed on, press the switch in so that it lights up.
① MIC input jack
Balanced XLR microphone input jacks (1: ground; 2: hot; 3: cold)
② LINE input jacks
Balanced TRS phone jacks (T: hot; R: cold; S: Ground)
You can connect either balanced or unbalanced Jack plugs to this
socket.
③ GAIN control
Adjustment of the input signal level. To get the best balance between
the S/N ratio and the dynamic range, adjust the input signal level so
that the PEAK indicator (10) comes on just as the signal approaches its
maximum level.
④ Equalizer (HIGH, MID & LOW)
This 3-band EQ adjusts the channel's high, mid and low frequency
bands. The stereo channel has a 2-frequency band: HIGH & LOW.
Setting the knob to the "▼" position produces a flat frequency
response in the corresponding band. Turning the knob to the right
boosts the corresponding frequency band, while turning to the left
attenuates the band. The following table shows the EQ type, frequency
and maximum cut/boost for each of the three bands.
Band
HIGH Shelving
MID Peaking
LOW Shelving
⑤ AUX Control
These knobs adjust the channel's signal levels into AUX BUSES.
⑥ EFFECT Control
Adjusts the level of the signal sent from the channel to the EFFECT bus.
Note that the signal level sent to the bus is also affected by the
channel fader.
⑦ PAN control
The PAN control determines the stereo positioning of the channel
signal on the STEREO L & R buses.
Type Frequency
12kHz
2.5kHz
80Hz
Max. Cut/Boost
± 15dB
3