Control Switches - Migatronic MULTIMOTIVE 220 Duo Manual De Instrucciones

1. Switch:
2-times symbol
Start welding by pressing the trigger on the
torch. Welding continues until the trigger is
released.
Spot symbol
The switch is set at Spot. When the trigger on
the torch is pressed, welding starts. Welding
stops automatically, depending on the time set
on control 4 (0.15-2.5 secs.)
Stitch symbol
The switch is set at Stitch. When the trigger is
pressed, welding starts. The welding auto-
matically stops, depending on the time set on
control 4. After an interval fixed at control 5 the
same cycle continues automatically and only
ceases when the trigger on the torch is
released.
4-times symbol
Welding starts the first time the trigger is
pressed (after which the trigger can be
released) and continues until the trigger is
pressed again to stop the welding process.
2. ON
Lights when the machine has been turned on.
3. Overheating
Lights if the welding process is automatically
stopped due to overheating of the transformer.
The light extinguishes when the transformer
temperature has dropped to normal, and weld-
ing can continue.

CONTROL SWITCHES

4.
5.
6.
7.
8.
9.
10.
11.1. Connection of welding hose 1
11.2. Connection of welding hose 2
12.
11
Welding time
With this control the welding time can be
infinitely varied between 0.15 and 2.5 secs
when switch 1 is set to position Spot or Stitch.
Pause time
With this control the pause time can be
infinitely varied when switch 1 is in position
Stitch.
Burn-Back
Variable time delay for wire to stop feeding
after voltage is switched off. This function is
used to prevent the wire sticking to the work-
piece or torch.
Variable between 0.05 and 0.5 secs.
Wire feed speed control
Reverser between welding torch 1 and 2
Switch for welding voltage
For machines with "Gas-test".
When set at "Gas-test", the gas flows when
the torch trigger is pressed.
Main switch
Inductance tappings