Installation
(continued)
Mounting the Tuner Unit
21
Caution
Never mount the unit in any of the following locations to avoid damage due to overheating;
• Near the heater port.
• Places like the dashboard or rear deck, where it may be exposed to direct sunlight.
Do not mount the unit near the door, where it could be exposed to rain.
You run the risk of interfering with the mounting or causing damage by drilling into the gas tank, a wiring harness, or
other component.
For mounting the unit on inclined surface, Velcro tape fi xation is too weak, and screw
fi xation is recommended.
Note:
Apply an anticorrosive to the holes and tapping screws.
Keep a safe distance between the unit and other electronic equipment.
Unit Installation by using the Tapping
Screw . (Recommended)
Tapping Screw
Tapping Screw
22
CY-TUN153U
Mount the unit on the car carpet
by using Velcro tape .
Attach the seal side of the Velcro Tape to the unit, then
mount the unit on the carpet.
Velcro Tape
Note:
Some carpet materials may not be suitable for this
mounting method. In this case, please contact your
nearest Panasonic Servicenter for installation.
Connecting the Parking Brake (Side Brake) Connection Lead
Caution
For safety, be sure to ask your nearest professional
installer to do this connection.
Hand brake
The parking brake (side brake) switch position varies with the car
model. For details on the exact location of the parking brake (side brake)
switch in your car, contact your dealer.
Clip connector
Parking Brake (Side Brake) Connection
Lead
(Bright green)
When the parking brake (side brake) lever
is engaged, the unit is grounded by the
chassis.
Attach a Clip Connector to the end of the parking
brake (side brake) connection lead.
Come up to this point.
Parking Brake (Side Brake)
Connection Lead
(Bright green)
Parking brake (side brake)
switch
Foot brake
Battery
Car chassis
Brake light
The Clip Connector is connected to the power
source side lead of the parking brake (side brake)
lever.
Power source side lead
CY-TUN153U
22
23