Greenlee CTR100 Manual De Instrucciones página 5

Operation (cont.)
• Attach the roller to the cable tray as shown in Figures
1 through 3 above, depending on the type of flange
used on the tray.
• Orient the roller so that the unit opens on the inside of
the tray as shown in Figure 6.
• Alternately, the roller can be mounted in a mirrored
orientation as shown in Figure 3.
• To secure the roller on the cable tray, tilt the handle as
shown in Figure 4 and push the handle until its pad
contacts the web of the tray's beam. Then, tilt the
handle into the original orientation, as seen in Figure
5, and turn the handle clockwise until tight.
• Pull the spring-loaded release pin to pivot the roller
and insert or remove cables, as shown in Figure 6.
Be sure to securely re-lock the pivoting roller
when closed.
• To remove the roller from the cable, turn the handle
counter-clockwise to loosen, then tilt the handle (as
shown in Figure 4) to remove it. The roller may now
be removed from the cable tray.
Greenlee Tools, Inc.
5
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070
CTR100