Archos DVR STATION Manual De Usuario página 15

DVr stAtioN
Verifying the channel list
1. From the " TV Control
2. This list was created from the channel line-up you selected during the TV Program Guide activation. Verify
that the channel list on the ARCHOS is the same as on your tuner.
3. Here you can deselect/select a channel or change the number of a channel.
setting the infrared eMitter
1 test: turning your tuner off
st
1. From the " TV Control
the codes and parameters so that the ARCHOS can turn your tuner on/off automatically (for a scheduled
recording).
TV Receiver
2. " ": select the type of tuner that you want to control with the IR Emitter ("
box ", " Satellite Receiver
3. " Receiver brand ": choose the brand of your tuner. You can use the
to scroll the list faster.
Test power Off code
4. Select the "
to turn your tuner off. After a few seconds, your ARCHOS will ask you if the device responded correctly:

If your tuner turned off, select "

If your tuner did not turn off, select "
ing a different code. Repeat this operation until the ARCHOS manages to turn the tuner off.
If none of the codes work, check that the DVR Station is positioned in a way that allows the infrared signal to reach your
tuner's receiver. Note: In some rare cases the ON/OFF functionality may not work.
" screen, select " Set TV Channel List
• The DVR Station has a high-powered infrared LED, located on the front of
the device, at the same place as the remote control receiver.
• It allows your ARCHOS device to communicate with your tuner (VCR,
cable box, satellite receiver or Digital TV receiver), so that it can turn it on
and off, and change channels on it.
• This is a one time step to set your ARCHOS device to send the correct
infrared codes to control your tuner. If you do not plan on making sched-
uled recordings, then you do not need to set the infrared emitter code.
" screen, select " Set Infrared Emitter
", " DVD Recorder " or "
" button. Make sure that your tuner is on. Your ARCHOS device will then try
Yes
", and move on to the next section.
No, try next code
".
". This first screen allows you to correctly set
Digital TV ").
". Your device will try turning the tuner off again, us-
User ManUal - version 1
VCR Cable/DSL
", "
buttons on the remote control
15