Philips HD 1500 Instrucciones De Manejo página 25

XP SBC HD 1500/17 for USA 14-01-2004 13:34 Pagina 25
Headphone
1 On/off switch: check if the power button of the headphone is in the on
position.
2 System status LED: the system status LED on the control panel will indicate
the status of the headphone by means of different colours and different
blinking modes Some of these modes also have an audible alarm.The table
will show all possibilities of system status and alarm sounds.
Definition Indication
Power on but LED: RED on
no radio signal
Power on and LED: GREEN on
tuned
Tuning/searching LED: GREEN blinking
Battery running LED: RED blinking
low Sound: 1 serie of
(5x100 ms) beeps
Battery empty Sound: 3 series of
(5x50 ms) beeps(headphone will go
in power save mode once the
batteries are empty)
Power save mode LED: RED blinking (2 seconds)
and short GREEN burst (all other
indicators on the headphone are
turned off)
Out of range Sound: 1 serie of
(5x200 ms) beeps
ENGLISH
Required action
Press tuning button on headphone
or change transmission channel on
base station or switch on transmission
function on base station
You have a limited time to replace the
batteries before the headphone will
go in power save mode.
Replace the battery pack.
Please read point 7 of this chapter on
the next page.
Move closer to the base station.
25