Publicidad
Idiomas disponibles
Idiomas disponibles
Product Dimensions
A. 35%" (91.1 cm) cooktop
height (minimum) with
leveling legs screwed all
the way in*
B. Model/serial/rating
plates
(located behind the
control panel)**
C. 463/4" (118.7cm)
overall height
(minimum) with levering legs
screwed all the way in*
D. 28W' (71.3 cm) depth with
handle
E. 26%6" to 27¼" (66.8 to
69.2 cm)***
E 29%" (75.9 cm) width
*Range can be raised approximately 1" (2.5 cm) by adjusting the
leveling legs.
**Model/serial/rating
plates may be rotated up from behind the
control panel for viewing from the front of the range.
***Excludes handle. Dimension given is from wall to front of oven
door and will vary based on electric outlet receptacle
installation.
Cabinet Dimensions
Cabinet opening dimensions shown are for 25" (64.0 cm)
countertop depth, 24" (61.0 cm) base cabinet depth and
36" (91.4 cm) countertop height.
IMPORTANT:
If installing a range hood or microwave hood
combination
above the range, follow the range hood or
microwave hood combination
installation instructions for
dimensional clearances above the cooktop surface.
Range may be installed with zero clearance to combustible
construction
at the rear and on the sides below the cooktop.
I
I
I
I
G
\
10"
(25.4 cm)
1¼"*
(5.7_
(3.1 cm)
A. 18" (45.7 cm) upper cabinet to countertop
B. 13" (33.0 cm) upper cabinet depth
C. 30" (76.2 cm) min. opening width
D. For minimum clearance to the top of the cooktop, see NOTE.
E. 30" (76.2 cm) min. opening width
F. 3" (7.6 cm) min. clearance from both sides of the range to the side
wall or other combustible
materiaL
G. 3" (7.6 cm) distance from wall
H. Cabinet door or hinges should not extend into the cutouL
I. Clearance for gas pressure regulator
*Drill on centerline 11A '' (3.1 cm) from rear wall for gas supply
line.
**Gas lines and electrical plugs must be installed within the
shaded area to ensure proper alignment of this oven with
cabinets.
NOTE: 24" (61.0 cm) minimum when bottom of wood or metal
cabinet is protected by not less than 1/4"(0.64 cm) flame retardant
millboard covered with not less than No. 28 MSG sheet steel,
0.015" (0.4 mm) stainless steel, 0.024" (0.6 mm) aluminum or
0.020" (0.5 mm) copper.
30" (76.2 cm) minimum clearance between the top of the cooking
platform and the bottom of an unprotected
wood or metal
cabinet.
Publicidad
