Set-Up And Operation; Safety Features - Kasanova HOH000008 Manual De Instrucciones

10
TERMOVENTILATORE PORTATILE

SET-UP AND OPERATION

- Make sure that the heater is switched off (O pushed in) then plug into a
correctly functioning 220-240 V/50 Hz socket.
- Now set the main switch to I (on); the heater is no won standby and the
indicator loght (7) light up.
- Switch on the heater by pressing the ON/STANDBY BUTTON.
- After switching in by means of the main switch, the thermostat i son the
maximun 30°. Press the "Temperature lower" button to set the desired
temperature (mínimum 15°). With the "Temperature higher" Button you
can higher the set temperatire afterwards. The display shows the set
temperatura.
- The thermostat will now regulate the heater to turn on if the tenperature
is too low and off once the desired temperatura is reached.
- Press Temp+ and Temp- at the same time to speed up the fan or to slow
it down. The display shows for a momento flashing what you have set:
LL= low HH=high.
- Press the timer button to set the timer. The display changes from
degrees to hours. Hold in button to enter more hours, up to a máximum of
12.
If you set the timer while the heater is on, you set the number of hours
after which the heater turns itself off. -To switch off the heater you must
first set it to standby by pressing the ON/standby button. The heater will
stop heating, but the fan coolsfor another 60 second (see display) before
switching off. You can then use the main switch to turn off the heater
properly (O pressed). Never leave the plug in the socket when the heater
is not in use.

SAFETY FEATURES

In case of internal overheating, the overheating safeguard will switch the
heater off. This may occur of the heater cannot give off enough heat ori f
it cannot draw in enough fresh air. As mentioned above, this is generally
caused by (partially) covering the heater or obstructing the air intake and/
or outlet girlls or installing the heater too close to a wall or something
similar. When the overheating safeguard switches the heater off, you need
to turn the switch to the "O position" (off) and remove the heater from
the socket. Allow the heater to cool down and make sure that whatever
caused the overheating is removed or amended. The heater can then be
reused. If the problema persists ori f you cannot find an obvious cause for
the overheating, turn the heater off immediately and take the plugo ut of
the socket.