■ Assemble reflector to back of lantern. Position
the reflector clips onto the center of the two
back rails and
slide either upward
into the reflecting
position or
downward into the
storage position.
(Fig. 12)
Fig. 12
■ Reflecting position.
■ Storage position.
Bottom tab rests
Reflector hangs from
inside lantern frame.
back rails. (Fig. 14)
(Fig. 13)
Fig. 13
Fig. 14
CAUTION
Keep all connections and fittings clean.
Inspect propane cylinder and lantern propane
connections for damage before attaching.
During set up, check all connections and
fittings for leaks using soapy water. Bubbles
indicate a leak. Never use a flame.
Match Light
INSTASTART™
Lantern
Electronic
Ignition Lantern
■ Push lighted match
■ Open burner valve
through lighting hole,
and repeatedly push
hold near mantle and
igniter button and
open fuel valve fully.
ignite the mantles.
(Fig. 15)
(Fig. 16)
Fig. 15
WARNING
or in use.
NOTE: If lantern does not
light, repeat above step. If
the lantern does not light
after several attempts,
check for a spark while
clicking the igniter. If no
spark is present, check
the electrode gap. The
gap should be about
.2" (5.0 mm). Carefully
bend electrode to set
gap. If the lantern is wet
due to rain, high humidity, etc., the electrode may
not spark. Use lighting procedure for match light
version lanterns. (Fig. 17)
■ Brightness may be
adjusted with
fuel valve. (Fig. 18)
To Turn Off
■ Turn fuel valve
off. (Fig. 19)
To Store
■
is cool.
■
from flame (including
pilot lights) and other
ignition sources.
■ Remove propane
cylinder from lantern.
(Fig. 20)
■ Replace protective cap
on propane cylinder .
■ Lantern can
be placed in
base for secure
storage. (Fig. 21)
DANGER
Fig.16
flames, pilot lights, direct sunlight, other igni-
tion sources or where temperatures exceed
120 degrees F (49°C).
lantern is in storage.
English - 4
.2"
(5.0 mm)
Fig. 17
Fig. 18
Fig. 19
Fig. 20
Fig. 21