Descargar Imprimir esta página

Changing The Dust Filter Bag - Silvercrest vSBS 1400 A1 Instrucciones De Utilización Y De Seguridad

Aspirador de bajo consumo

Publicidad

Idiomas disponibles

Idiomas disponibles

4
Maintenance

4.1 Changing the dust filter bag

Change the dust filter bag at the latest
when the electronic dust filter bag change indi-
cator (Fig. 16) lights up or the suction power
has decreased.
16
ATTENTION:
When leaving your working-area, switch off
the appliance and mind the notices at
chapter 3.3, „Switching off and retracting
power cord". In this way you avoid dust
destroying the appliance.
1. Fold back the carrying handle (Fig. 17/1.)
2. Open the dust compartment cover by un-
latching and then lifting it (Fig. 17/2.).
17
1.
3. Lift the dust compartment cover until it locks
in the highest position and remains open by
itself.
NOTE:
Be careful when removing the dust filter bag
so that no dust escapes.
4. Release the dust filter bag by pulling back
the holding-clip (Fig. 18/1).
5. Then pull the bag up and out (Fig. 18/2).
18
6. Remove any dust that may have collected
in the dust compartment.
NOTE:
You can dispose of the dust filter bag with
your regular domestic trash if it contains no
prohibited waste materials.
7. Insert the new dust filter bag into the bottom
side of the holder first (Fig. 19/1).
NOTE:
The arrow ( ) on the cardboard shield of the
dust filter bag shows the insertion direction
and must point down.
8. Then press it upwards against the holding-
clip (Fig. 19/2.) until this locks the bag into
its position.
19
2.
9. Close the dust compartment cover. It clicks
shut audibly.
NOTE:
The dust compartment cover can only be
closed with a dust filter bag in place.
Maintenance
4.2 Changing filters
Your cylinder vacuum cleaner is equipped with
the following filters:
20
Motor protection filter (Fig. 20/1) pre-
vents larger particles from destroying the motor
in case the dust filter bag is defective.
Changing: Every time you open a new box of
dust filter bags, as these always contain a new
motor protection filter, but at least every 6
months.
Hygienic exhaust filter (Fig. 20/2)
moves microscopic particles from the exhaust
air stream.
Changing: every 6 months
The filters can become clogged with time and
reduce the appliance's performance. That's
why it is important to adhere to the above
changing intervals.
Damaged filters must be replaced immedi-
ately.
ATTENTION:
These filters are not washable. The hygienic
exhaust filter may not be re-used.
NOTE:
If the motor protection filter is only slightly
dirty, it can help to beat out the dust over a
dustbin. However, we recommend to change
the motor protection filter each time you
open a new box of dust filter bags ( chapter
5.1, „Accessories and Spare Parts").
re-
GB
IE
19

Publicidad

loading