Tm-10H Models; Cleaning; Lubrication - Diamond TOAST-MAX TM-5H Manual De Instalación Y Funcionamiento

TM-5H & TM-10H MODELS
1. Plug toaster into a properly grounded electrical outlet
of the correct voltage, size and plug configuration. See
SPECIFICATIONS for details.
2. To toast the top and bottom sides of the bread, place
the SELECTOR SWITCH in the bread position. The indicator
light will glow at this time. See 10 .
To toast one side only (the top side), place the SELECTOR
SWITCH in the bun position. The indicator light will glow
at this time. See 10 .
3. Turn the COLOR CONTROL to the lightest position while
the unit heats up. See 10 .
NOTE: Allow approximately 15 to 20 minutes
for a warm-up period.
4. After warm-up period, set the COLOR CONTROL
to the medium position and toast two slices of bread product
then re-adjust the COLOR CONTROL to the desired setting.
GENERAL
The Hatco Toast-Max Electric Conveyor Toasters are designed
for maximum durability and performance, with
minimum maintenance.
WARNING
To avoid any injury, turn the power switch OFF, unplug
the unit from the power source and allow to cool before
performing any maintenance.

CLEANING

WARNING
This appliance is not of jet-proof construction. Do not use
jet-clean-spray to clean this appliance.
Exterior
To preserve the bright finish of the unit, it is recommended
that the exterior surfaces be wiped daily with a damp cloth.
Stubborn stains may be removed with a good stainless steel cleaner
or a non-abrasive cleaner. Hard to reach areas should be cleaned
with a small brush and mild soap.
CAUTION
Use only non-abrasive cleaners. Abrasive cleaners could scratch
the finish of your Toast-Max toaster marring its appearance
and making it susceptible to soil accumulation.
Toast Crumb Tray & Toast Collector Pan
Remove from unit and wash with soap and water, then rinse.
NOTE: To toast moist products such as English Muffins, rye bread
or whole wheat, slow the conveyor by turning the COLOR
CONTROL knob to a darker setting (clockwise).
All TM series toasters can be put into a Power Save mode
by placing the selector switch in the standby position. The toaster
is operating at 25% power in the Power Save mode. See 10 .
NOTE: To place toaster back into full operation turn the selector
switch to the Bread or Bun position. Unit is back up and ready
for toasting within 5 minutes.
Toast Feed Ramp
Press in the two wire spokes and remove guide from unit. Wipe
clean with a soft, damp cloth or soak the guide in a mild solution
of 227 milliliters of ammonia and 3.785 liters of water (1 cup
and 1 gallon). Re-install guide by aligning wire spokes
with holes in toaster.

LUBRICATION

The conveyor gear motor and conveyor system
are permanently lubricated and require no lubrication.
If service is required on this unit, contact your Authorized
Hatco Service Agent, or contact the Hatco Service Department
at 414-671-6350; International fax 414-671-3976.
This product has no "user" serviceable parts. To avoid damage
to the unit or injury to personnel, use only Authorized Hatco
Service Agents and Genuine Hatco Parts when service
is required.
Genuine Hatco Replacement Parts are specified to operate
safely in the environments in which they are used. Some
aftermarket or generic replacement parts do not have the
characteristics that will allow them to operate safely in Hatco
equipment. It is essential to use Hatco Replacement Parts when
repairing Hatco equipment. Failure to use Hatco Replacement
Parts may subject operators of the equipment to hazardous
electrical voltage, resulting in electrical shock or burn.
8
OPERATION
MAINTENANCE
WARNING
WARNING
WARNING
Form No. TMCEM-0404