Connections; Microphone System Operation; Muting Functions - Sony WRR-805A Manual De Instrucciones

Connections

Caution
When connecting the unit to a camcorder, be sure to turn the
unit off.
Connect the OUTPUT (BAL) connector to the microphone
input connector on DSR-200, DCR VX-1000 or other
camcorders by using the supplied cable.
To secure the output cable connection, be sure to turn and
lock the connector cover as illustrated below.
For attaching the unit to a camcorder, see "Use of the Soft
Case" on page 16.
To monitor audio output, connect the headphones to the
MONITOR connector. The monitoring level can be adjusted
by turning the MONITOR control.
US
14

Microphone System Operation

1
Set the MUTING switch ON before turning on the tuner.
2
Turn the POWER switch on.
3
Set the reception channel.
For details on setting the channels, see page 11.
4
Set the MUTING switch OFF, and turn on the transmitter
or the wireless microphone.
If noise is heard
Depending on the environment where the system is
installed, outside noise or radio wave may disrupt the
transmission of certain channels.
To select a channel under this circumstance, turn off the
wireless microphone or transmitter. Then select a channel at
which the RF indicator is off. (A channel free from noise or
radio wave interference is selected.) Set the same channel on
the microphone or transmitter.

Muting Functions

When the MUTING switch is set to ON, the following
muting functions work in combination.
(1) Muting by RF input level
As sufficient S/N for the audio output may not be obtained if
no RF signal is received or the RF input level is low. The