Vax Air Cordless Manual De Instrucciones página 29

Clearing a blockage from the brushbar
Remove battery and lie the
stick vac flat. Squeeze the
brushbar clips towards
the brushbar and lift off
brushbar cover.
IMPORTANT: If the brushbar has been obstructed the Motor Protection Sensor may have been
activated. Remove the battery and clear any obstruction. Wait 30 minutes for the stick vac to reset
itself. Replace the battery, recline and switch on the stick vac. If the brushbar still does not turn press
the brushbar on /off button.
Changing the brushbar – additional brushbars are available at vax.co.uk
Remove battery and
lie the stick vac flat.
Squeeze the brushbar
clips towards the
brushbar and lift off
brushbar cover.
Replace the brush
bar cover by clicking
into place.
Using a pair of scissors
cut any hair or debris
from around the
brushbar.
Multi-floor brushbar
Hard-floor brushbar
Choose brushbar.
TIP: Multi-floor brushbar has longer, softer bristles designed for all round
cleaning on carpets and hard floors.
Hard-floor brushbar has extra soft bristles, designed specifically for the
gentle removal of dirt/debris from hard floors.
To purchase go to www.vax.de
Maintenance
Replace the brushbar
cover by clicking into
place.
Remove brushbar
firstly lifting the side of
brushbar not connected
to belt.
Replace brushbar,
fitting the belt to the
brushbar first. Then
aligning both sides of
the brushbar into base.
29