MAXIMUM WSR-4000 Manual De Usuario página 7

TROUBLE SHOOTING
1. When there is no picture presented, please:
• Make sure the direct connection from source device to sink device can
work properly.
• Check if all connectors are connected well; check if all cables can
support the transmission speed. High Speed HDMI cables are
recommended.
• Unplug the power cable to restart WSR-4000.
2. When there is no sound:
• Please try to adjust the volume of TV.
• Check cable connection to see if it fits properly.
• Check cable to see if it supports video transmission only (DVI) or it is
damaged.
• HDCP may not match very well at first connection; please unplug the
power cable to restart WSR 4000.
3. If the video is unstable, or "snowing image" shows on screen.
• You might get interference form other wireless device or heavy
power consumption house-ware (ex. Wi-Fi Router, Microwave, air
conditioner...). Please keep WSR-4000 away from those sources of
interference.
• The wireless transmission distance may be too far or blocked by wall or
other object. Please place WSR-4000 at other location where you can
get good signal and video quality.
• Please change the direction of Transmitter and Receiver stand to get
better reception.
4. If the wireless connection fails.
• Please make sure the power of source device, which you want to use, is
turned ON.
• Unplug the power cable to restart WSR-4000.
5. If the TX side is normally playing the video but RX side HDTV has no signal,
• Please check if your source device's output video resolution is set at 4K
/ 60Hz, if yes, please get into manual setting and reset it to Auto, If No
Auto option, please reset it manually into output resolution 4K/30Hz or
other lower resolution which can meet TV or Projector resolution.
• Unplug the power cable to restart WSR-4000.
ENGLISH
7