Unpacking And Contents - Genesis GCID18K Manual Del Operario

UNPACKING AND CONTENTS

IMPORTANT:
Due to modern mass production techniques, it is unlikely the tool is
faulty or that a part is missing. If you find anything wrong, do not operate the tool until
the parts have been replaced or the fault has been rectified. Failure to do so could result
in serious personal injury.
CONTENTS IN PACKAGE
Description
Impact Driver
Wall Adaptor
Charger Stand
OPERATION
WARNING:
important safety warning and instructions before using this tool.
:
NOTE
Always Check that the power supply corresponds to the voltage on the ratings
plate.
CHARGING THE TOOL (FIG 2)
• Use only the Battery Charger that is included in this kit to
recharge your batteries.
• Use only 120 Volt AC power source.
• Charge your batteries fully before using the driver for the first
time.
• Connect the wall adaptor (2) to charger stand (3)
•
Plug the wall adaptor (1) into a 120 Volt AC power source. The
red light on the charger will illuminate, indicating the charger is
power on.
• Insert the battery (1) into the slot on the charger stand (3). Make
sure that the battery is seated firmly in the charger. The green
light on the charger will illuminate, indicating that the battery is
charging.
• Charge for 3 hours before initial use, and after normal use. If driver has been used continuously, and the battery
is completely discharged, it may require up to 5 hours to fully recharge the battery.
• The red and green lights will remain lit, even after charging is complete.
• Batteries may become warm while charging. This is normal.
• If battery is hot after continuous use in the driver, allow it to cool down to room temperature before charging.
This will extend the life of your batteries.
• Other tips for extending battery life: Do not store batteries completely discharged. Charge them fully before
storing, and if drill is not used for a long time, take the batteries out and charge them periodically.
WARNING:
tool or place the switch in the locked or off position before
any assembly, adjustments or changing accessories.
WARNING:
switched off before insertion or removal of the battery pack.
INSTALLING OR REMOVING THE BATTERY PACK
(FIG 3)
•
To install the battery pack, insert the battery pack into the tool housing
as shown in FIG 3. Always insert it all the way until it locks in place with
a click. Lightly pull on the battery to ensure it is locked into place and will
not accidentally fall out of the tool, causing an injury.
18V Impact Driver
Operator's Manual
Q'ty
1
1
1
To reduce the risk of serious personal injuries, read and follow all
Always disconnect battery pack from
Always be sure that the tool is
Description
Bit
Case
Operator's Manual
3
1
FIG 3
GCID18K
Q'ty
1
1
1
2
FIG 2
1