Samsung WF42H5000A Serie Manual Del Usuario página 17

4, Slide y our w asher into position.
5, Level your w asher byturning t he leveling legs inorout a s
necessary byhand orbyusing t hewrench i ncluded with your
washer.
When y our w asher islevel, tighten thelocking n uts using t he
wrench o r(-)flathead screwdriver.
6, Plug thepower cordinto a3-Prong, well g rounded 120 volt
60Hzapproved electrical outlet protected bya 15-amp fuse
orcomparable circuit breaker.
Your washer isgrounded through thethird prong o fthe
power cord when plugged into athree-prong grounded
receptacle.
Your washer must b eleveled onallfour s ides. Acarpenter's
level should b eused onall f our corners ofyour w asher. We
recommend yourecheck your w asher after a dozen o rso
washes tomake sure it'sstill l evel.
_ void damage tothelegs. D onotmove
thewasher unless theLocking-nuts are
fastened tothebottom ofthe washer.
Test run
Make sure that you install your washing machine correctly by running the Rinse+Spin cycle
after the installation is complete.
STEP 4
Calibration mode
Your Samsung washing machine automatically detects the weight of the laundry.
For more accurate weight detection, please run Calibration Mode after the installation.
To run Calibration Mode, follow these steps:
1. Turn on the washer.
2o Press the Tempo button and Belay End button simultaneously for at least 3 seconds.
3, Remove any contents in the tub and close the door.
4, Press the Start/Pause button.
5, The drum rotates clockwise and counterclockwise for approximately 3 minutes.
6, When Calibration Mode is finished, the "En/End" appears on the display and the washing
machine turns off automatically. The washing machine is now ready for use.