Publicidad
F E AT U R E S - O P E R AT I O N S
TECHNICAL SPECIFICATIONS
• Amps: 12.5
• Wattage: 1500W (+5% –10%)
• Working voltage: 120V AC/60Hz
FCC STATEMENT
Potential for Radio/Television interference
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired
operation.
Warning: Changes or modifications to this unit not
expressly approved by the party responsible for
compliance could void the user's authority to operate the
equipment.
NOTE: This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC rules.
These limits are designed to provide reasonable protection
against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that the interference will
not occur in a particular installation. If the product does
cause harmful interference to radio or television
reception, which can be determined by turning the
product on or off, the user is encouraged to try to correct
the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the product and the
receiver.
• Connect the product into an outlet on a circuit
different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV
technician for help.
OPERATING INSTRUCTIONS
1. Carefully remove your heater from the box. Please
save the carton for off-season storage.
2. Place heater on a firm, level surface.
3. Plug heater into a standard outlet. Once plugged in,
the Power Light will illuminate.
NOTE: Avoid overloading your circuit by not using other
high wattage appliances in the same outlet. At 1500
watts, this unit draws 12.5 Amps.
4. Press the Power Button ( ) to start operation.
Mode Control
Press the MODE Button to select the desired heat settings.
Each press of the button will cycle through the below
settings and the selected setting will appear on the LCD:
HI - HIGH Heat
The heater will run continuously at 1500W.
LO - LOW Heat
The heater will run continuously at 900W.
CONTROL PANEL
Figure 1
A
E
A. POWER BUTTON
B. LCD DISPLAY
C. MODE BUTTON
B
C
D
F
D. POWER LIGHT
E. UP/DOWN BUTTONS
F. OSCILLATION SWITCH
Publicidad
