Publicidad
EMPTY RECOVERY TANK
Unplug
carpet cleaner from electrical
outlet.
Automatic
"shut
off"
When the recovery tank (lower tank) is full, the
automatic shut-off mechanism will shut off the carpet
cleaner suction (suction will be noticeably reduced).
The carpet cleaner will no longer pick up dirty solution
and the motor sound will become noticeably higher in
pitch.
When this happens, turn carpet cleaner off and empty
recovery tank before continuing use.
Check the solution tank also; it may need to be
refilled.
Never use unit w{thout
the orange float or float
retainer, located in the recovery
tank, in place. If
broken or dislodged,
take to a Sears Parts and
Repair Center for repair.
_Release
latches (A) located on either side of
recovery tank (B) by pushing latch toward rear of
carpet cleaner.
_Slide
tank (B) straight out and carry it to a sink
or drain. Remove lid.
_Empty
tank through opening (C). To remove any
debris that has collected on the lint screen (D),
flush with water.
Check to be sure that the orange float and float
retainer, located in the recovery
tank, are in pmace.
If broken or dislodged,
take to a Sears Parts and
Repair Center for repair.
_Reposition
lid by aligning hinges (E) at rear of
tank. Press down on front of lid to secure in
place. Replace tank.
Push latches (one on each side of tank) toward front
of carpet cleaner to lock tank in place. Be sure both
sides are properly latched.
ON/OFF PEDAL and
HANDLE
RELEASE
PEDAL
_Step
on pedal (A) to turn carpet cleaner on.
Step on pedal again to turn carpet cleaner off.
Step on pedal (B) to lower handle to operating
position. Handle does not Jock into a singJe position
but "floats" to alJow convenient operation.
14
Publicidad
