SKF LAHD 500 Instrucciones De Uso página 9

" " (495) 727-22-72
11. Adjust the oil level in the application to the required level and assure that this
corresponds to a level between the two lines marked on the lower reservoir.
If necessary, adjust the height of the lower reservoir by means of the support bracket
screw.
12. Screw the upper reservoir tightly onto the lower reservoir ensuring that the
extended neck is flush with the oil level in the lower reservoir. Use the six rubber
gaskets to obtain the correct height. (Ensure the gasket with the smallest bore
remains on top).
13. For high precision applications use the support bracket screw for the fine tuning
(otherwise the accuracy will depend on the thickness of the gaskets).
14. Unscrew the cover of the upper reservoir and fill it with the same oil as used in the
application.
15. Screw back the cover tightly, ensuring that no air can enter into the upper reservoir.
This will also open the valve at the bottom of the upper reservoir and hence connect
the upper and lower reservoir to each other.
16. Start the machine. As the oil in the application will lower due to splashing, oil will
flow from the lower reservoir into the application, exposing the extended neck to
open air. This will allow air to enter the upper reservoir and hence oil to flow down to
the lower reservoir. Once the oil has reached the preset level, air can no longer pass
to the upper reservoir, effectively stopping the flow of oil.
N.B.: During stand-still the oil will stop splashing and the level in the application will rise.
As a consequence the oil level in the oil leveller will also rise above the preset level.
SKF LAHD 500-1000
promshop- biz@ya.ru
level
oil
oil level
www.promshop.biz
level
oil
oil level
7