Sartorius YRD03Z Instrucciones De Funcionamiento página 6

6 6
§ Reconnect the mains unit jack plug.
Note:
! Do not use the mains connector socket on the
remote display.
The power is supplied to the remote display via the
data cable.
For technical reasons, the scale must remain
!
voltage-free in this position. Do not plug in the
mains unit. Do not apply voltage to the scale!
§ Place the fixing plate (the countersunk holes point
upwards) so that the center foot of the scale is
inserted through the hole.
§ Push the remote display onto the scale.
§ Insert the countersunk screws into the threaded
bushings and tighten them in order to fasten the
fixing plate.
§ Turn over the scale and the remote display.
> The remote display is now installed.
§ Bring the scale with the remote display to the place
where it is to be set up.
§ Reconnect the power supply. Plug in the mains unit.
§ Switch on the scale (ON/OFF switch).
§ Calibrate/adjust the scale before use
(see operating instructions).