Using The Settings Menu - VDO A2C15587800 Instrucciones De Uso

Using the settings menu

To...
open the settings menu
scroll the possible values or commands Yes and
No
confirm the value or command and move to the
next setting
exit the settings menu
Note: settings can only be scrolled forward. To change a previous setting, exit the settings menu and open it
again.
Example procedure
Following is the procedure to set Engine instance = 3
1. Turn on the device holding down the button until "Settings" appears: the Config units setting
appears.
2. Hold down the button until No blinks once: the Config engine instance setting appears.
3. Briefly press the button to view Yes, then hold it down until Yes blinks once: the Engine instance
setting appears with the current value.
4. Briefly press the button to scroll values until 3 is displayed.
5. Hold down the button until it blinks once: the Config analog inputs setting appears.
Settings description
Setting
Speed units of measure
Speed
Temperature Temperature units of measure
Pressure Pressure units of measure
Volume units of measure
Volume
Depth units of measure
Depth
Displayed data engine, NMEA 2000 code.
Engine
instance
Type of sensor data on input 1
Input pin 8
Type of sensor data on input 2
Input pin 9
Start sensor calibration
Do sens.
calibration
Impulses per engine revolution
Config RPM
Speed source
GPS source
Speed displayed by the device pointer
Pointer
indication
Value to be added/subtracted from the depth to
Offset
compensate for the transducer position compared to the
waterline or keel
GPS speedometer | Operating instruction v. 1.0 | A2C15587800 | 05-2017 | © 2017 Continental Automotive Switzerland AG
Then....
turn on the device holding down the button until "Settings" appears: the
Config units setting appears
briefly press the button
hold down the button until the value or command blinks once
select the setting Exit settings and then the command Yes or turn the
device off and back on: the first data page appears.
Description Possible values/commands*
kmh/ mph/ kts
°C/ °F
bar/ PSI/ kPA
Ltr/ gal
ft/ mtr
0/ 1/ 2/ 3
Off: no connected analog sensor
l
Trim: trim, propeller tilt
l
Fresh: fresh water level
l
Fuel: fuel level
l
Rudder: rudder angle
l
For information on sensor calibration, see "Sensors
calibration" on page 33.
From 0.0 to 999.9 (default = 1.0)
Int: built-in GPS module
l
Ext: via NMEA 2000
l
SOG: speed over ground
l
STW: speed through water
l
From -99.9 to + 99.9
General settings
31