Evans GT190MG3500BS Manual De Propietario página 6

EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.
BATTERY INSTALLATION
PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIE
Before installing the battery, remove the key from
EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.
the Control Panel of your generator.
1
Set the battery holder on the frame and secure it with the
screw, washer and nut as shown in the drawing.
PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIE
2
Place the battery on the battery holder.
Secure the battery using the brackets attach on the
3
battery holder.
EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.
Identify the red and black wires with positive and negative
4
electrodes of the battery.
Connect the red wire to the positive terminal of the
5
battery and the black wire to the negative terminal.
PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIE
(See Fig.
Handle the battery carefully as it contains highly corrosive
acid and can cause burns. Never connect the red wire to
black, this can cause damage to physical integrity and
EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.
the equipment.
PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIE
EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.
PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIE
EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.
ENGINE CONTROLS
Choke
PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIE
EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.
PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIE
EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.
PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIE
EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.
PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIE
EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.
PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIE
6
CAUTION
Dipstick
CONTROL PANEL
OPS
20 A Overload
Protection System
127 VAC
Receptacle
GENERATOR SET UP AND CABLE
CONNECTIONS
1
Place the generator outdoors where it will be used. This
must be a flat surface. and far from flamables materials.
Do not allow the generator gets wet.
2
Fill the tank fuel (outdoors) up to 10.5 gallon of gasoline,
do not fill the tank up to the top of tank.
3
After removing the plug with dipstick located in one side
of the engine, fill with 2.4 liter of oil. Fill with SAE 30 oil.
Use a funnel to avoid the spill of the oil. Review the oil
level by means of the dipstick, it must mark "Full". Place
the plug with plastic dipstick, carefully, to avoid damage
of the threads.
4
Before connecting the equipment to the generator
review that the equipment is Off. Read the section
DETERMINING TOTAL WATTAGE . Do not overload the
generator. Calculate the total power of the equipment.
The maximum power of the generator is indicated in the
specification sheet.
GENERATOR ELECTRIC CONTROLS
& OUTLETS
WARNING
WARNING: If the Generator will be used to
replace facility power in times of outages, the
facility power input must be isolated. Refer to the
Electric Generator Safety Precautions.
These connections must only be made by a licensed
electrician.
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE
Main Breaker
Digital
Hourmeter
127/220 VAC
Receptacle
Voltmeter