Replacing The Lamp; Replacing The Lamp Winecellar - De Dietrich PSS500 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

46
Problem
The temperature in the
freezer is too high.
There is too much frost.

Replacing the lamp

1. Disconnect the mains plug from the
mains socket.
2. Press on the rear hook and at the same
time slide the lamp cover in the direction
of the arrow.
3. Replace the lamp with one of the same
power (the maximum power is shown on
the light lamp cover)
4. Install the lamp cover by sliding it into its
original position.
5. Connect the mains plug to the mains
socket.
6. Open the door. Make sure that the lamp
comes on.

Replacing the lamp Winecellar

1. Disconnect the mains plug from the
mains socket.
2. Remove the lamp cover by pressing it in-
wards with a tool (e.g. screwdriver) to free
the rear side hookings.At the same time,
free the middle hook and slide off the
cover in the direction of the arrows.
3. Replace the used lamp with a new lamp
of the same type and having the same
characteristics.
4. Install the lamp cover.
5. Connect the mains plug to the mains
socket.
Possible cause
Products are too near to each
other.
Food is not wrapped correctly.
The door is not closed correctly.
The temperature regulator is not
set correctly.
Store products so that there is cold
air circulation.
Wrap the food correctly.
Refer to "Closing the door".
Set a higher temperature.
6. Open the door. Make sure that the lamp
comes on.
Solution

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido