Installing Batteries - Tasco Propoint Manual Del Propietário

installing Batteries

CAUTION: BE SURE GUN IS NOT LOADED WHEN INSTALLING BATTERIES.
Should your reticle grow dim or not light at all, you will need to replace
the battery/batteries (see "Lithium Battery Reference Chart" for the type
and quantity of battery). To install new battery(ies), unscrew the battery
compartment and insert with "+" side up. Replace battery cover.
ZerOing YOur prOpOint
Note: THE FOLLOWING SHOULD BE DONE AT AN APPROVED RANGE OR OTHER SAFE AREA.
EYE AND EAR PROTECTION IS RECOMMENDED.
1. Activate the illuminated reticle by turning the rheostat knob
clockwise to brighten and counterclockwise to dim. The "1"
represents the dimmest and the "11" the brightest illuminations.
2. Remove the windage and elevation adjustment caps.
3. With the scope mounted, rest the gun on a solid support. Sight along
the barrel and aim at a target 50 to 100 yards away. Sight through
6
your ProPoint and use the windage and elevation adjustments to
align the lighted reticle with the target as seen along the barrel.
Each click of adjustment moves the point of impact by the amount
written on the adjustments.
4. Using the polarizing filter (if included): The polarizing filter may
be used with or without the extension tube attached. It may be
positioned on the objective end of the ProPoint or at the end of the
extension tube. Note: To attach filter directly to the objective end,
remove the Trim Ring first.
5. Using the sunshade (if included): Under some lighting conditions,
reflections may be noted in the eye lens. To reduce or eliminate
reflections, thread the sunshade onto the eyebell. Note: The sunshade
may also be used to gain added space between front and rear rings
if needed, when mounting on extra long action rifles. To use as an
extension, first remove the rubberized eye guard from the eyebell,
then thread the sunshade into position.
7