Technical Data; Noise/Vibration Information; Declaration Of Conformity - Bosch ALR 900 Manual Original

OBJ_BUCH-835-002.book Page 20 Friday, October 10, 2008 8:40 AM
20 | English

Technical Data

Lawnraker / Verticutter
Article number
Rated power input
Cutting width
Grassbox, capacity
Cutting system
– Double wound tines
– Pivoting blades
Collection system
Height of cut
Weight according to EPTA-Procedure
01/2003
Serial number

Noise/Vibration Information

Measured values determined according to
2000/14/EC (1.60 m height, 1.0 m distance
away) and EN ISO 5349.
Typically the A-weighted noise levels of the
product are: Sound pressure level 78 dB(A);
Guaranteed sound power level lower than
94 dB(A). Uncertainty K =3 dB.
The hand-arm acceleration is typically below
2
2.5 m/s .

Declaration of Conformity

We declare under our sole responsibility that
the product described under "Technical data" is
in conformity with the following standards or
standardization documents: EN 60335 accord-
ing to the provisions of the directives
2004/108/EC, 98/37/EC (until 28 Dec 2009),
2006/42/EC (from 29 Dec 2009), 2000/14/EC.
2000/14/EC: Measured sound power level
92 dB(A). Conformity assessment procedure
according to Annex V.
Technical file at:
Bosch Lawn and Garden Ltd., PT-LG/EAE,
Stowmarket, Suffolk IP14 1EY, England
Leinfelden, 01.07.2008
F 016 L70 481 | (10.10.08)
ALR 900
3 600 H8A 0..
W 900
cm 32
l 50
Jet Collect
mm +10/+5/0/-5
kg 9.9
See serial number 10 (type plate) on the machine
Dr. Egbert Schneider
Senior Vice President
Engineering
01.07.2008, Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
Assembly
For Your Safety
Warning! Switch off, remove plug from
mains before adjusting, cleaning or if cable
is cut, damaged or entangled.
The tines/blades continue to rotate for a
few seconds after the machine is switched
off.
Caution – do not touch rotating
tines/blades.
Always wear gardening gloves when han-
dling or working near the sharp tines/blade.
AVR 1100
3 600 H8A 1..
1100
32
50
–
–
Jet Collect
+5/0/-5/-10
10.4
Dr. Eckerhard Strötgen
Head of Product
Certification
Bosch Power Tools