QUNDiS gateway 5.5 direct Instrucciones De Uso Y De Instalacion página 22

EN - Operating and Installation Instructions Q gateway 5.5 direct
Mounting point requirements:
The GSM/UMTS signal strength can be determined at the gateway via the control menu, using the
pears on the display. Move the Q gateway 5.5 direct to a location with a better GSM/UMTS signal and repeat the process.
the building and repeat the procedure.
menu using the Scan
The following tools are necessary for correct mounting:
•
• Cross-slot screwdriver or cordless screwdriver
•
• In addition for Q gateway 5.5 direct RNG5000T1x:
Before wall mounting
RNG5000T1x only
6
RNG5000T1x only
14
6
• Open the housing cover.
•
power supply board with the plug
14
the main board using the enclosed
mains connection cable.
22
• Open the housing cover.
• Plug the battery connector into the power supply connector
is started. The green LED
• Close the battery compartment
• Insert the enclosed hexagon nut
the inside in
the
To do this, push the nut into the guide
6 on
FUM5-00AM-DES-G5521
5
7
.
• Screw the enclosed cable gland
. through-hole on the
Q gateway 5.5 direct.
-
Q SMP
6 .
V2.1 / 06.06.2019