i.t.works SUNW2 Manual De Instrucciones página 9

AIR PRESSURE HISTORY BAR CHART
1. The bar chart indicates the air pressure history trend over the last 12 hours in 6 steps: 0h,
-1h, -2h, -3h, -6h and -12h.
2. The "0h" represents the current full hour air pressure recording.
3. The columns represent the "hPa" at specific time.
4. If the bars are rising, it means that the weather is getting better due to the increase of air
pressure.
5. If the bars go down, it means the air pressure has dropped and the weather is expected to
get worse from the present time "0h".
Remarks: Moving your weather station from one floor of a building to another floor will affect the
accuracy of your weather station, which should operate at the same altitude all the time. If you move
it to a new location, it will take 12-24 hours to stabilise and be accurate again.
Our weather station provides the next 12-24 hours weather forecast. It may not match with the
current weather condition outside.
TEMPERATURE AND HUMIDITY TENDENCY INDICATORS
Appears when the current measured temperature / humidity is 1°C or 5% higher than
the last measurement of temperature and humidity
Appears when the current measured temperature / humidity is 1°C or 5% lower than the
last measurement of temperature and humidity
Appears when the current measured temperature is within +/-1°C or +/-5% from the last
measurement of temperature or humidity in the last 1 hour
TO READ MAXIMUM-MINUMUM INDOOR-OUTDOOR TEMPERATURES, HUMIDITY AND AIR
PRESSURE
Simply press the MEM button to view the maximum indoor-outdoor temperatures and humidity, the
air pressure records with "MAX" icons will appearing on the display. Press again to view the minimum
indoor-outdoor temperatures and humidity and the air pressure records and "MIN" icons appearing on
the display.
When the maximums or minimums are displayed, press and hold the MEM to reset both records and
it will start to record the maximums and minimums again.
IF YOU LOSE THE OUTDOOR TEMPERATURE AND HUMIDITY
When the outdoor temperature and humidity digits show "---": the wireless transmission has been
interrupted or lost. Press and hold the + / CHANNEL button and your weather station will start to
search for the signal from the transmitter. If you continue to lose the outdoor temperature
and humidity display, which could happen in extreme cold weather, try placing the transmitter in a
different location until you have smooth transmission of temperature / humidity data.
TROUBLESHOOTING
If your weather station clock shows irrelevant information or digits, it maybe affected by electrostatic
discharge or interferences from other devices. Use a sharp object to press RESET on the back of the
weather station. Your unit will be reset to default settings and you will need to set the time, calendar
and alarm time again.
Problem
LCD is blank
No Outdoor Temperature and
Humidity is displayed
Solution
1. Press RESET on the main unit.
2. Replace fresh batteries in your weather station.
1. Press and hold MEM on the weather station.
2. Press and hold MEM, then press RESET on the
transmitter.
3. Make sure the correct channel is selected on your
EN.8