Safety Instructions; Environment Concerns - Dieter Knoll Collection DK6HP660X Manual De Instrucciones

SAFETY INSTRUCTIONS

The use of exposed flames is detrimental to
the filters and may cause a fire risk, and must
therefore be avoided in all circumstances.
Any frying must be done with care in order to
make sure that the oil does not overheat and
ignite.
CAUTION: Accessible parts of the hood
may become hot when used with cooking
appliances.
For lamp replacement use only lamp type
indicated in the Maintenance/Replacing lamps
section of this manual.
WARNING! Do not connect the appliance
to the mains until the installation is fully
complete.
With regards to the technical and safety
measures to be adopted for fume discharging
it is important to closely follow the regulations
provided by the local authorities.
The ducting system for this appliance must not
be connected to any existing ventilation system
which is being used for any other purpose such
as discharging exhaust fumes from appliances
burning gas or other fuels.
Do not use or leave the hood without the lamp
correctly mounted due to the possible risk of
electric shocks.
Never use the hood without effectively mounted
grids.
The hood must NEVER be used as a support
surface unless specifically indicated.
Use only the fixing screws supplied with the
product for installation or, if not supplied,
purchase the correct screws type.
Use the correct length for the screws which are
identified in the Installation Guide.
In case of doubt, consult an authorised service
assistance centre or similar qualified person.
WARNING! Failure to install the screws
or fixing device in accordance with these
instructions may result in electrical hazards.
14

ENVIRONMENT CONCERNS

Recycle the materials with the symbol
. Put the packaging in applicable containers
to recycle it. Help protect the environment and
human health and to recycle waste of electrical
and electronic appliances. Do not dispose
appliances marked with the symbol
household waste. Return the product to your
local recycling facility or contact your municipal
office department for household waste or the
shop where you purchased this product.
USE
The hood is designed to be used either for
exhausting or filter version
INSTALLATION
The mains power supply must correspond to the
rating indicated on the plate situated inside the
hood. If provided with a plug connect the hood to
a socket in compliance with current regulations
and positioned in an accessible area, after
installation. If it not fitted with a plug (direct mains
connection) or if the plug is not located in an
accessible area, after installation, apply a double
pole switch in accordance with standards which
assures the complete disconnection of the mains
under conditions relating to over-current category
III in accordance with installation instructions.
Warning!Before re-connecting the hood
circuit to the mains supply and checking
the efficient function, always check that the
mains cable is correctly assembled.
with the
.