Kasanova SWO000017NOC Manual De Instrucciones página 16

CORDLESS STEAM IRON
16
- Slowly pour the water into the reservoir using the special measure and
taking care not to go over the maximum level (about 280ml) indicated by
"MAX" on the reservoir [Fig. 2].
- Close the Filler door (C).
Selecting the temperature.
- Put the iron in a vertical position.
- Put the plug in the socket.
- Adjust the thermostat knob (I) according to the international symbol on the
garment label [Fig. 3]. The plate indication light (L) indicates that the iron
is heating up. Wait until the plate temperature control light goes off before
ironing.
Warning: during ironing, the plate temperature control light (L) comes on at
intervals, indicating that the selected temperature is maintained. If you lower
the thermostat temperature after ironing at a high temperature, do not start
ironing until the plate temperature control light comes on again.
Selecting the steam:
The quantity of steam is regulated by the steam selector (D).
- Move the steam selector to a position between minimum and maximum
depending on the quantity of steam required and the temperature selected
[Fig. 1].
Warning: the iron gives off steam continuously only if you hold the iron
horizontally. You can stop the continuous steam by placing the iron in a
vertical position or by moving the steam selector to " ". As indicated on
the thermostat knob (I) and in the initial table, you can only use steam at the
highest temperatures. If the selected temperature is too low, water may drip
onto the plate.
- Selecting Shot-steam and steam when ironing vertically.
- Press the shot-steam button (F) to generate a powerful burst of steam that
can penetrate the fabrics and smooth the most difficult and tough creases.
Wait for a few seconds before pressing again [Fig. 4].
- By pressing the shot-steam button at intervals you can also iron vertically
(curtains, hung garments, etc.) [Fig. 5].
Warning: the shot-steam function can only be used at high temperatures.
Stop the emission when the plate temperature control light (L) comes on, than
start ironing again only after the light has gone off.