Salicru PLC Serie Manual De Usuario, Instalación Y Puesta En Marcha página 23

5.2.- Output connections.
• The system of input and output Neutral are identical "without galvanic isolation" for the voltage stabilisers RE2. The
line conditioners PLC2 can be connected to the system of neutral desired. For system with isolated neutral, the wire
bridge linking the output terminal to the earth terminal should be removed.
• Connect the critical loads to the power outlets (2) depending on the model.
6.- START UP AND STOP OF THE EQUIPMENT.
• Check that the indications about the installation in chapter 5 have been respected.
• Verify that the input fuses (4a and 4b) are duly placed, in the models that correspond.
• Power up to the input of the equipment. The "Input" (a) Led will light.
6.1.- To turn on an equipment with the structure according to figure 1.
• Turn the switch (5) to the position "On" or "I", the equipment supplies regulated output voltage. The Led (b) "Power On"
and (f) "Output" will light up.
The daily turning on of the equipment should be done by means of this switch (5).
• In case that some of the Led (c) "Bypass A (R)", (d) "Bypass B (S)" or (e) "Bypass C (T)" will light up, please contact
your nearest After Sales Service (A.S.S.) The equipment can remain connected but it does not regulate; however the line
conditioners PLC2 will supply a voltage free of electrical noise.
6.2.- To turn on an equipment with the structure according to figure 2.
• Turn the switch (5) to the position "On" or "I", the equipment supplies the output voltage directly from the raw mains
through the Bypass. The Led (f) "Output" lights up.
• From the moment that the raw mains has been powered up and the switch (5) has been turned on, the power will
be present at the output terminals through the Bypass.
• Turn the switch (6) in the position (
light up. The led (c) "Bypass A (R)", (d) "By-pass B (S)" and (e) "Bypass C (T)", will also light up for some instants, as
a result of the auto-testing.
The daily turning on of the equipment shuld be done by means of this switch (6).
• By means of the voltmeter (7) it is possible to verify the voltage at the output terminals, either when it is supplied by the
raw mains through the Bypass, or when it comes regulated from the equipment. Besides, the three phases equipment are
fitted with a voltmeter's commutation switch (8) which permits to select the voltage phase to neutral or phase to phase
to be verified on the voltmeter (7).
), the equipment supplies regulated output voltage. the led (b) "Power on", will
- 23 -