Isotherm DR 150L Instrucciones De Uso página 16

ENGLISH
MAINTENANCE
Warning
Before every maintenance operation, disconnect the power supply from the main connector.
- Always ensure that the condensate trap discharge hole is not blocked.
- In the instance of excessive build-up of ice around the evaporator, check that the gasket seal is correct.
- In the instance where the fridge is not used for long periods of time or in the case of voluntary defrosting,
switching off or disconnecting the appliance from the electric mains, we recommend placing a water
entrapment container in the area under the small freezer drawer. The container must be larger than the
drawer itself, in order to trap the water from the defrosting process (see Fig. 10).
In case of refrigerator wrong operation, contact the Isotherm Service Center.
Fig. 10
USEFUL ADVICES
If the refrigerator does not work, or if it works wrongly, before referring to our after sales service, make
sure that:
a) power is not missing,
b) the voltage which reaches the main connector is equal to the one shown on the label,
c) the connections are correctly made,
d) the ventilation grids are not obstructed,
e) the refrigerating unit is not near a source of heat,
f) the fuse mounted on the power line is not blown.
Warning
The power cable must be replaced only by qualified technical personnel and, in any case, by a service
authorized by the manufacturer.
Isotherm disclaims any responsibility if the above instructions and conditions are not followed or
not met.
14
DRAWER 150L-12V
DRAWER 150L-12V_rev.04_03-2014