Assembly - Agri-Fab SpeedEPart 25-0126 Manual Del Usuario

1
12
4
8
FIGURE 1
ASSEMBLY INSTRUCTIONS
Tools Needed:
(2) 17mm Open End Wrench
(1) 14mm Open End Wrench
(1) 13mm Open End Wrench
(1) Pliers
1. Verify that all parts and all fasteners (shown full size)
on page 4 are included in the carton and parts bag.
Refer to page 4 to identify fasteners used in the fol-
lowing instructions.
2. With the Log Splitter (3) standing on end, attach the
Hitch Assy (1) using two M10 x 25 Hex Bolts (6) and
secure with two M10 Hex Nuts (12). Be sure that all
bolts are tight. (Figure 1)
3
6
7
6
4
FIGURE 2
3. Attach Axle Assy (4) to the Log Splitter (3) using four
M8 x 25 Hex Bolts (7) and secure with four M8 Hex
Nuts (8). Be sure that all bolts are tight. (Figure 1)
4. Slide the Wheel (5) on to the Axle Assy (4) with the
long hub facing inwards. Slide a 1/2" Flat Washer (9)
onto the outside of the axle. Secure with Cotter Pin
(17) and bend the ends with a pair of pliers. Repeat
for other wheel. (Figure 2)
5. This Log Splitter will attach and tow behind any stan-
dard lawn and garden tractor. Use the supplied Hitch
Pin and Haircotter Pin to attach to tractor. In addition
there is a hitch located on the rear of the unit which
allows you to tow a cart behind the Log Splitter.
6. As shown during assembly, this unit will stand on its
end for easy storage.
5
9
17