in-lite SENTINA 150X150 Manual De Instrucciones página 4

EN
Contents
1x SENTINA 150X150 12 V / 3.5 W
Dimensions 150 x 150 mm / 5.9 x 5.9 inches
Recess depth 100 mm / 3.9 inches
1x Easy-Lock
1x Torx key
Material
Impact-resistant polycarbonate lens
Stainless steel cover plate
Please read the following instructions before installing. You are
advised to keep these installation instructions in a safe place.
Although a 12 V system is safe, we advise you to have a qualified
electrician check the installation.
Use
Integrated accent lighting for special features in the yard such as
trees, shrubs, statues and exterior walls.
This fixture is fitted with a tilting light unit. To use this loosen the four
Torx bolts and remove the cover and lens. Tilt the light unit into the
desired position (it can be raised or lowered max. 15 degrees), and
replace the lens and cover. Retighten the Torx bolts.
Lamp
The fixture is equipped with a high-quality LED lamp. These lamps
have a long life (about 25,000 hours) and a high light output and their
power consumption and the heat produced are extremely low.
Important!
Never connect the low-voltage cable directly to a 100-240 V power
source. It is only suitable for use in combination with a 12 V low-voltage
system. This product should only be used within the in-lite system. Use
of products other than those made by in-lite will invalidate the warranty.
Enjoy the lighting in your yard.
EN
Connecting the fixture to 12 V
The already installed lamp means the fixture is immediately ready for
use. Therefore you do not need to install the lamp first. This fixture can
be built into various sorts of decorative paving, such as concrete or
natural stone.
Step 1
Replace a 150 x 150 mm / 5.9 x 5.9 inch stone with this fixture or, in the
case of large, unbroken surfaces, saw out a 150 x 150 mm / 5.9 x 5.9
inch piece. The fixture can then be placed directly on the underlying
sand bed.
Step 2
Join the Easy-Lock connector to the main cable. (Fig. 1)
a. There are two cable grips. The grip with the wider recess fits the
10/2 main cable, the grip with the narrower recess fits the 14/2
main cable. Clamp the correct cable grip over the main cable.
b. Put the cable grip (with the cable underneath) in the Easy-Lock
connector.
c. Tighten the threaded cap on the Easy-Lock connector. This will
cause the contacts to be pushed through the insulation on the
cable. In tightening the cap, a little gel is applied to the contacts in
the Easy-Lock connector. This serves to protect the contacts
against moisture. A little gel may possibly come out of the Easy-
Lock connector: so after installation (and/or before a meal), wash
your hands with soap and water, and avoid the gel coming into
contact with your eyes.
Step 3
Connect the main cable to the fixture by connecting the mini-
connector. (Fig. 2)
If the lamp does not work correctly, check that the Easy-Lock connec-
tor is properly connected to the main cable. Do the same for the mini-
connector. Repeat steps 2 and 3. When the fixture is connected to the
main cable also check that the contacts of the Easy-Lock connector
are not bent. If you have any problems, contact your dealer.
General maintenance advice
We advise wiping the fixture down at least once a year using a clean
cloth and warm water.