Parts Of The Device; Operation; Switching On/Off - Festool MX 1600/2 REQ DUO Instrucciones De Servicio Originales

Stirrer
2nd gear
Electronic speed pre­
selection
2-speed switch
Stirrer – max. dia.
Collet dia.
Spindle clearance
Weight as per EPTA
procedure 01:2014
5

Parts of the device

[1-1] Stirring tool
[1-2]
Tool holder
[1-3] Locking pin
[1-4]
Speed control
[1-5] Right handle
[1-6]
Safety lock
[1-7] On/off switch with speed control
[1-8] Auxiliary handle
[1-9] Speed selector switch
[1-10] Dust extraction system MX-A
The specified illustrations appear at the begin­
ning of the Operating Instructions.
6

Operation

WARNING
Unauthorised voltage or frequency.
Risk of accidents
► The mains voltage and the frequency of the
power source must correspond to the
specifications on the name plate.
► In North America, only Festool machines
with the voltage specifications 120 V/60 Hz
may be used.
WARNING
Risk of injury, electric shock
► Always disconnect the mains plug from the
socket before performing any work on the
machine.
MX 1600/2 REQ DUO
130–350 rpm
O
O
140 mm
57 mm
110 mm
8.1 kg
WARNING
Hazardous dust
► Wear a dust mask.
WARNING
Risk of injury, electric shock
► Allow the power tool to acclimatise before
use.
6.1

Switching on/off

CAUTION
Risk of injury
► Always hold the power tool with both hands
– one on the right handle [1-5] and one on
the auxiliary handle [1-8].
CAUTION
Heating of the Plug it connection if bayonet
fitting is not completely locked
Risk of burns
► Before switching on the power tool, make
sure that the bayonet fitting at the mains
cable is closed fully and locked.
For connecting and detaching the mains power
cable, see figure [2].
Switching on
► Activate the [1-6] safety lock.
► Press and hold down the on/off
switch [1-7].
The on/off switch cannot be locked.
Switching off
► Release the on/off switch [1-7].
6.2 Electronics
Smooth start-up
The electronically controlled smooth start-up
ensures that the machine starts up jolt-free.
At the same time, this also prevents the materi­
als to be stirred from spurting out of the mixing
container. Thanks to the low starting current of
the machine, a 16 A fuse is sufficient.
Idling speed reduction
The electronics reduce the speed of the ma­
chine when idling, thereby reducing noise and
wear on the motor and gearbox.
Speed control
You can use the speed control [1-4] to set the
speed.
English
15