To Replace System Components If Needed - Honeywell RedLINK FocusPRO Guia De Instalacion

Replacing system components
Thermostat
To replace a thermostat, install batteries and follow the procedure on page
4 to link it to the wireless network. If necessary, modify settings as needed
(see tables on pages 7-9).
Remote control & outdoor sensor
To replace a remote control or outdoor air sensor, install batteries and
follow the procedure on page 5 to link it to the wireless network.
TrueZONE panel & wireless adapter
After installing a new zone panel or wireless adapter, you must re-set the
thermostat and remote control to communicate with the new equipment, as
described below.
At the thermostat:
1 Press and hold the
2 Press twice to display Function 39 (wireless setup).
BACK
▼
3 Press to change Function 39 setting to 0 (disconnect from old
equipment).
4 Follow the procedure on page 4 to link to new equipment.
At the remote control:
1 Press and hold the blank space (or arrow if present) in the lower right
corner of the screen until the display changes (about 3 seconds).
2 Press
REMOVE
3 Follow the procedure on page 5 to link to new equipment.
▲
and
FAN
, then to disconnect from old equipment.
YES
Español: vea la página 16 • Français : voir la page 31
buttons for 3 seconds.
Press and hold for
about 3 seconds
13