Operation - BABYTREND HC07A Manual De Instrucciones

ASSEMBLY
TO ATTACH AND OPERATE TRAY
WARNING:
check that the high chair is
locked in the open position
before using.
WARNING:
not designed to hold the child
in the chair. The child should
be secured in the high chair
at all times by the 5-point
restraining system, either in
the reclining, semi-reclining or
upright position.
TO ATTACH TRAY
9) • To attach the Tray, line up the grooves on
the bottom of the tray with the armrests of
the high chair. Squeeze the Tray's release
handle and slide the tray onto the armrests
(Fig. 9a). The Tray has a 3-position
adjustment. To adjust the position,
squeeze the Tray's release handle located
underneath the tray and reposition the tray
to the desired position (Fig. 9b). Release
the Tray's handle.
NOTE: Check that the Tray is securely
locked in its new position.
TO ATTACH INSERT TRAY
10) • The dishwasher safe food Tray Insert snaps onto the High Chair Tray and is
held in place by tabs on the sides of the Tray. When installing the Tray Insert
make sure that it snaps into place to prevent the child from removing the
Tray Insert. To remove Insert unsnap tabs from the Tray.
• The Tray may be stored on the back legs of the High Chair. Align the holes in
the rear of the tray with the small pegs on the back legs (Fig. 10).
7
Copyright © 2017, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
Always
The tray is
Tray Release located underneath tray
3-position
TO USE SAFETY BELT
WARNING:
children capable of sitting upright unassisted use the
high chair in the upright position.
WARNING:
from falls or sliding out. Always use the restraint
system. The child should be secured in the high chair
at all times by the 5-point restraining system, either in
Fig. 9a
the reclining, semi-reclining or upright position.
The Tray is not designed to hold the child in
the chair. Stay near and watch child during
use. leave child unattended.
NEVER
11) • The shoulder straps of the 5-point
harness have 2 attachment positions.
Select the position that places the
shoulder strap level with, or below, the
Fig. 9b
top of the child's shoulders (Fig. 11a).
• Carefully place the child in the seat and
position the safety harness around the
child's waist and over the shoulders.
Place the crotch strap between the
child's legs. Insert the male end of each
shoulder/waist belt into the buckle on
the crotch strap. Tighten the harness
to be snug around the child's waist and
Fig. 10
over the child's shoulders (Fig. 11b).
TO RELEASE SAFETY BELT
12) • Push Button on Center Clasp, the two
Harness Buckles will pop free (Fig. 12).
Copyright © 2017, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.

OPERATION

It is recommended that only
Prevent serious injury or death
Adjust for a snug fit
Center Clasp
Fig. 11a
Fig. 11b
8
Fig. 12