Homeguard BS8000 Manual De Usuario página 9

Before using HomeGuard, the base station has to learn this specific code from each
remote or sensor:
1. Enter your PIN (Personal Identification Number). Factory default is [0000] see (5): You
will hear three high tones and one low tone as confirmation. The green indicator starts
flashing.
2. Press 1 on the keyboard of the HomeGuard: One high tone is given for confirmation.
3. Press the ARM button on your remote, or the test button of the sensor: One low tone is
given for confirmation.
Repeat step 1-3 for a second up to fourth remote and/or sensor if required.
4. Press any button on your HomeGuard keyboard to finalise the registration procedure:
One short low tone is given and the green indicator stops flashing.
If no successive commands are entered within a period of 15 seconds, the base station
returns to normal operation. To restart the registration you start the procedure from step1.
*Sensors applicable:
DS10: Can be used as PANIC sensor; will generate alarm ALWAYS.
DS18: Can be used as REGULAR sensor; will only generate alarm in ARMED
mode, or PANIC alarm in respond to TAMPER alarm.
8. DELAY ARM
The alarm mode may be activated by either the remote control or by the keyboard. If the
remote control is used, the HomeGuard arms and disarms instantly. If you require a delay,
in order to allow yourself to leave or enter the room before arming or disarming the
HomeGuard, you may set the HomeGuard to Delay Arm:
1. Enter your PIN (Personal Identification Number). Factory default is [0000]: You will hear
three high tones and one low tone as confirmation.
The green indicator starts flashing.
2. Press 7 on the keyboard of the HomeGuard: One low tone is given for confirmation.
3. Press [ * ] for Delay Arm or # for Instant Arm: One tone is given for confirmation and the
indicator stops flashing.
9. SIREN
Your HomeGuard is equipped with a built-in siren. This siren will frighten intruders so they'll
leave the house. If you require a so-called silent alarm (without siren), you can change the
factory default:
1. Enter your PIN (Personal Identification Number). Factory default is [0000]: You will hear
three high tones and one low tone as confirmation. The green indicator starts flashing.
2. Press 3 on the keyboard of the HomeGuard: One low tone is given for confirmation.
3. Press [ * ] for Siren On or # for Silent Alarm: One tone is given for confirmation
and the indicators stops flashing.
HomeGuard revision 01-05-2005
9