Before Starting The Equipment - ALPHA-TOOLS FMR 1100 Manual De Instrucciones

Anleitung FMR_1100_SPK7:_
GB
Wear ear-muffs.
The impact of noise can cause damage to hearing.
Total vibration values (vector sum of three directions)
determined in accordance with EN 60745.
Drilling in metal
Vibration emission value a = 2.82 m/s 2
h
K uncertainty = 1.5 m/s 2
Important!
The vibration value changes according to the area of
application of the electric tool and may exceed the
specified value in exceptional circumstances.

5. Before starting the equipment

Before you connect the equipment to the mains
supply make sure that the data on the rating plate
are identical to the mains data.
Always pull the power plug before making
adjustments to the equipment.
5.1. Fitting the additional handles
The additional handles (6) enable you to achieve
better stability whilst using the equipment. Do not use
the equipment without the additional handles.
5.1.1 Fitting the additional handle (6a) (Fig. 2)
The additional handle can be secured in any of
three positions (A, B, C).
5.1.1 Fitting the additional handle (6b) (Fig. 3)
The additional handle (6b) is secured to the back
of the equipment with a screw (b).
5.2 Fitting the mixing tool (Fig. 4)
Always pull the power plug before making
adjustments to the equipment.
Undo the chuck by turning it anti-clockwise with
the supplied chuck key (7).
To ensure that it is perfectly positioned the mixing
tool or tool should be inserted as far as possible
into the chuck. After inserting the mixing tool or
tool, tighten the chuck (1) by turning the chuck
key (7) clockwise until the mixing tool or tool is
secure. Check that the drill bit is secure in the
mixing tool (1).
Check at regular intervals that the mixing tool or
tool is secure (pull the mains plug).
Do not attempt to make this setting whilst the
equipment is in use.
10
24.06.2008 9:04 Uhr Seite 10
6. Operation
6.1 ON/OFF switch (Fig. 5/Item 3)
First fit a suitable mixing tool in the equipment
(see 5.2).
Connect the mains plug to a suitable socket.
To switch on:
Press the ON/OFF switch (3)
Continuous operation:
Secure the ON/OFF switch (3) with the locking
button (2).
To switch off:
Press the ON/OFF switch (3) briefly.
6.2 Adjusting the speed (Fig. 5/Item 3)
You can infinitely vary the speed whilst using the
tool.
Select the speed by applying a greater or lesser
pressure to the ON/OFF switch (3).
Low pressure on the ON/OFF switch (3): Lower
speed
Greater pressure on the ON/OFF switch (3):
Higher speed
6.3 Preselecting the speed (Fig. 5/Item 4)
The speed setting ring (4) enables you to define
the maximum speed. The ON/OFF switch (3) can
only be pressed to the defined maximum speed
setting.
Set the speed using the setting ring (4) on the
ON/OFF switch (3).
Do not attempt to make this setting whilst the
equipment is in use.
6.4 Clockwise/Counter-clockwise switch (Fig.
5/Item 5)
Change switch position only when the drill is
at a standstill!
Set the running direction of the paint and mortar
mixing tool using the clockwise/counter-clockwise
switch (5):
Direction Switch position
Clockwise
Counter-clockwise