Mains Connection - BH H8705 Instrucciones De Montaje

handlebar stem (B) and the monitor
(E), figure 10.
Insert the monitor
handlebar stem (B), as shown in figure
10, making sure not to pinch any of
the cables. Fit the bolts (s) along with
the flat washers, making sure that the
handlebar is
securely tighten all of the bolts on the
handlebar stem including the bolts at
the base which were left hand tight in
point 4.
Mod. H871.-
Bring the monitor (E) to the handlebar
stem (B) figure 11, connect the two
terminals (P / Q) coming out of the
handlebar stem (B) and the monitor
(E), figure 11.
Insert the monitor
handlebar stem (B), as shown in figure
11, making sure not to pinch any of
the cables. Fit the bolts (s) along with
the flat washers, making sure that the
handlebar is
securely tighten all of the bolts on the
handlebar stem including the bolts at
the base which were left hand tight in
point 4.
Mod. H872N.-
Bring the monitor (E) to the handlebar
stem (B) figure 11, connect the two
terminals (P/Q; y/v) coming out of the
handlebar stem (B) and the monitor
(E), figure 11.
Insert the monitor
handlebar stem (B), as shown in figure
11, making sure not to pinch any of
(E) onto
aligned correctly,
(E) onto
aligned correctly,
(E) onto
the cables. Fit the bolts (s) along with
the flat washers, making sure that the
the handlebar
securely tighten all of the bolts on the
handlebar stem including the bolts at
the base which were left hand tight in
point 4.
LEVELLING
Once the unit has been placed into its
fi nal po- sition, make sure that it sits
flat on the floor and that it is level. This
is achieved by screwing the adjustable
foot (U) up or down, figure 12.
MOVEMENT & STORAGE.
The unit is equipped with wheels (V)
to make it easier to move about. The
two wheels at the front of the unit
the
make it easier to place the unit in any
chosen position, as shown in the
figure 13. Store it in a dry place,
preferably not subject to changes in
temperature.

MAINS CONNECTION

Insert the jack (m) on the transformer
(g) into the connection hole (k) on the
main body (A) (bottom, rear of the
machine)
transformer into a 220 V mains supply,
Figure 14.
BH RESERVES THE RIGHT TO
MODIFY THE SPECIFICATIONS OF
ITS PRODUCTS WITHOUT PRIOR
the
NOTICE
12
is aligned
and then plug
correctly,
the